1. The shaking when the car starts is the gearbox Question. This kind of failure is generally more common in manual transmission models.
2. The common reason for car start-up jitter is that the throttle valve is too dirty or the fuel injector has too much carbon.When the engine accumulates too much carbon, the gasoline sprayed by the fuel injector head during cold start will be absorbed by a large amount of carbon accumulation, resulting in excessive mixing gas during cold start and difficulty in starting.
3. This kind of jitter may be caused by indentation when the transmission gear and the transmission shaft mesh. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting. Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
1. The engine foot shakes. The automatic transmission car shakes badly when it is in the forward gear but has not started. It is likely that the engine foot has failed. In the process of using the car, the wear rate of the engine foot is much higher than that of other parts. After a long time or the engine foot Deformation and other problems may occur in certain quality defects.
2. This kind of jitter may be caused by indentation when the transmission gear meshes with the transmission shaft. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting.Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
3. Serious engine carbonization: Cars always have the problem of carbonization, including cylinder carbonization, throttle carbonisation, spark plug carbonation, intake carbonation, etc. When the engine accumulates too much carbon, it will affect the ignition energy, intake efficiency and air-fuel ratio of the car, resulting in unstable power output of the car, idling and acceleration jitter.
Solution: Check the oil pressure and replace the parts if necessary. Aging of engine parts. Car jitter is also related to the aging of engine feet (also known as claw pads).
When judging, set up the drive first.Bridge, plug the front wheel with safety plugs, start the engine and gradually change to high-speed gear, so that the drive wheel reaches the final test vibration speed. If the car body and the steering wheel shake at this time, it is the vibration caused by the transmission system.
It is relatively simple to solve this problem. You only need to replace the aging foot mat. It is recommended that the car owner choose the original accessories when replacing the foot mat.
International freight rate analysis-APP, download it now, new users will receive a novice gift pack.
1. The shaking when the car starts is the gearbox Question. This kind of failure is generally more common in manual transmission models.
2. The common reason for car start-up jitter is that the throttle valve is too dirty or the fuel injector has too much carbon.When the engine accumulates too much carbon, the gasoline sprayed by the fuel injector head during cold start will be absorbed by a large amount of carbon accumulation, resulting in excessive mixing gas during cold start and difficulty in starting.
3. This kind of jitter may be caused by indentation when the transmission gear and the transmission shaft mesh. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting. Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
1. The engine foot shakes. The automatic transmission car shakes badly when it is in the forward gear but has not started. It is likely that the engine foot has failed. In the process of using the car, the wear rate of the engine foot is much higher than that of other parts. After a long time or the engine foot Deformation and other problems may occur in certain quality defects.
2. This kind of jitter may be caused by indentation when the transmission gear meshes with the transmission shaft. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting.Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
3. Serious engine carbonization: Cars always have the problem of carbonization, including cylinder carbonization, throttle carbonisation, spark plug carbonation, intake carbonation, etc. When the engine accumulates too much carbon, it will affect the ignition energy, intake efficiency and air-fuel ratio of the car, resulting in unstable power output of the car, idling and acceleration jitter.
Solution: Check the oil pressure and replace the parts if necessary. Aging of engine parts. Car jitter is also related to the aging of engine feet (also known as claw pads).
When judging, set up the drive first.Bridge, plug the front wheel with safety plugs, start the engine and gradually change to high-speed gear, so that the drive wheel reaches the final test vibration speed. If the car body and the steering wheel shake at this time, it is the vibration caused by the transmission system.
It is relatively simple to solve this problem. You only need to replace the aging foot mat. It is recommended that the car owner choose the original accessories when replacing the foot mat.
How to detect supply chain inefficiencies
author: 2024-12-23 22:46HS code integration in digital customs systems
author: 2024-12-23 22:08Supplier risk profiling with trade data
author: 2024-12-23 21:47Global trade reporting frameworks
author: 2024-12-23 21:18Data-driven trade procurement cycles
author: 2024-12-23 23:18How to analyze competitor shipping routes
author: 2024-12-23 22:38Predictive trade data cleaning
author: 2024-12-23 21:26Trade data integration with CRM
author: 2024-12-23 21:04How to manage complex supply chains with data
author: 2024-12-23 21:01424.61MB
Check533.84MB
Check894.92MB
Check659.44MB
Check993.72MB
Check438.66MB
Check624.31MB
Check246.87MB
Check979.41MB
Check131.14MB
Check468.49MB
Check184.43MB
Check321.37MB
Check531.94MB
Check588.18MB
Check358.48MB
Check331.28MB
Check193.23MB
Check915.85MB
Check511.28MB
Check945.75MB
Check364.32MB
Check664.72MB
Check558.78MB
Check326.23MB
Check811.46MB
Check127.12MB
Check798.53MB
Check814.95MB
Check274.95MB
Check116.68MB
Check391.96MB
Check748.11MB
Check997.45MB
Check371.41MB
Check848.89MB
CheckScan to install
International freight rate analysis to discover more
Netizen comments More
414 Trade data for chemical imports
2024-12-23 23:14 recommend
1131 HS code-based invoice validation
2024-12-23 22:05 recommend
2425 HS code-driven margin analysis
2024-12-23 21:57 recommend
1231 Shipment data platform
2024-12-23 21:51 recommend
1980 HS code-based customs broker selection
2024-12-23 21:26 recommend