Russia HS code-based trade compliance

The Russia HS code-based trade complianceengine is the heart of the car and a very important part of the car. It plays an important function of converting fuel energy into mechanical energy.However, during the car maintenance process, we sometimes need to disassemble and install the engine. In order to ensure that the disassembly process can be carried out safely and effectively, there are a few points that need special attention. I. Preparations that need to be done before disassembly 1. Purchase or prepare necessary tools, equipment and parts. The tools and equipment required for engine disassembly are relatively complicated and need to depend on the specific situation. Two. Read the relevant technical materials and master the steps and precautions for disassembly. If necessary, you can ask a professional technician for more advice and guidance. 3. Carry out a safety inspection of the car, check the condition of brakes, suspension, tires and other parts, and ensure that the car can be safely disassembled and installed. II. Safety matters that need to be paid attention to during disassembly and installation 1. Safe operation and wearing of protective equipment. The disassembly and installation of the engine involves a lot of detailed operations, and it is necessary to ensure the safety of the operation.At the same time, you need to wear appropriate protective equipment, such as gloves, masks, goggles, etc. Two. Ensure the stability of the engine bracket and other parts. The engine is very important and huge, and needs to be supported by a professional bracket to ensure its stability. 3. You need to pay attention to the strength when disassembling and installing. During the disassembly and installation process, special attention should be paid to the operating force. Excessive force or overoperation may cause damage to the parts in the engine. III. Technical details that need to be paid attention to when disassembling and installing 1. The treatment of the emission system. During the disassembly and installation process, it is necessary to deal with the automobile emission system, such as intake pipes, exhaust pipes, etc., to ensure that the work can be carried out easily and avoid damage to the engine. Two. Treatment of electrical systems. During the disassembly and installation process, it is necessary to prevent damage to the electrical system. Therefore, it is necessary to unplug the car battery first, and control nearby electrical equipment when removing some key parts.3. Treatment of engine oil. In the process of disassembly and installation, it is necessary to deal with the oil and oil pits in the engine, which can be achieved by tilting the engine or setting up a bracket. Special attention should be paid to the quality of the oil, which is very important for the operation of the engine, so it needs to be handled carefully. IV. Matters to pay attention to after disassembly 1. Inspection of the installation process. After the disassembly is completed, the installation process needs to be checked to ensure that the installation position of all parts is accurate and correct. Two. The start-up and test of the vehicle. After the disassembly is completed, the engine needs to be started and a preliminary test is carried out to verify whether the normal operation of the engine and the market operation of the whole disassembly process are correct. 3. Reach the normal working temperature. After starting the test engine, we need to ensure that the engine reaches the normal operating temperature, which means that the cooling system relies on normal heat dissipation and heating modes to control the temperature.If there is a problem in this link, it will endanger the engine. In a word, the process of engine disassembly is complicated and requires professional knowledge. At any time, we need to be more careful and ensure safe operation, only in this way can we ensure that our work is done well.

Contact Us
Phone：020-83484615