customs transaction analysis

List of contents of this article:

• 1,How to clean throttle carbon
• 2, How to clean the throttleDoor
• 3 、 How to clean the car throttle valve?
• 4, How to clean the throttle valve?
• 5, The process and precautions for cleaning the throttle valve by yourself
• 6, Audi A4L throttle cleaning method' Washing method

How to clean the throttle carbon

1. ClearIt is very simple to wash the throttle valve carbon. You just need to remove the throttle valve, spray the detergent on the part with the carbon, and finally wipe it clean with a clean cloth. After installing the cleaned throttle valve, be sure to re-match the engine computer, otherwise it will lead to an increase in fuel consumption of the car.

2. How to clean up the carbon accumulation of the intake valve of the car There are three ways to clean up the carbon accumulation of the intake valve. 1 Add "fuel treasure", which is to add detergent to gasoline, which is the easiest to operate, but it is not easy to use. If it is a bottle before checking the car, it will have a certain impact. In daily use, fuel The cleaning effect of Bao is.

3. Car throttle cleaning method: first melt the carbon with throttle cleaner, gently push open the page with your hand, and brush the gap with a toothbrush;Clean the carbon with the carburetor cleaner; repeat several times until the original metal color leaks from the throttle valve.

4. Clean the throttle valve. If you want to quickly remove the carbon accumulation of the car engine, you must clean the throttle valve first. When cleaning, remove the outer cover of the engine and remove the throttle valve, and then clean the throttle valve with a carburetor cleaner. After cleaning, wipe it clean with a cotton cloth, and then Just put it in its original position.

How to clean the throttle valve

4 Apply a special cleaning agent or carburetor cleaner, spray it on the throttle valve, and wait for organic dissolution The agent melts the accumulated carbon, and wipe it clean after 1-2 minutes. The whole cleaning process must be disassembled - paint spray - cleaning - security _. The actual operation is very inconvenient, but the cleaning effect is very good.

The cleaning steps of the throttle valve are: turn off the ignition switch and remove the negative pole of the battery; remove the throttle cable, intake hose and screws fixing the throttle valve in turn; clean the throttle valve with detergent, and wipe the parts that cannot be cleaned with cotton thread.

Car throttle valve cleaningMethod: First, melt the carbon with throttle cleaner, gently push open the page with your hand, and brush the gap with a toothbrush; clean the carbon with a carburetor cleaner; repeat several times until the original metal color leaks from the throttle valve.

How to clean the car throttle valve?

1. Use a flat-head screwdriver to loosen the metal card of the air filter and the fastening screw of the throttle body, and separate the top cover of the air filter from the throttle body. It is best for two people to clean the electronic accelerator, one is responsible for stepping on the accelerator and the other is responsible for cleaning. Spray the carburetor cleaner on a clean rag, and then wipe it carefully with a rag.

2. First, open the engine cover of the car, then remove the intake pipe to see the throttle valve, turn off the ignition switch, then remove the negative pole of the battery, and straighten the baffle of the throttle valve. At this time, spray the detergent.

3. [Pacific Automobile Network] Car throttle valve cleaning method: first melt the carbon with throttle valve cleaner, gently push the page with your hand, and brush the gap with a toothbrush; wash the carbon with a carburetor cleaner; repeat several times until the original metal color leaks from the throttle valve.

4. The method is as follows. First, open the front machine cover and find the position of the throttle valve. The hose is as shown in the figure below. Tighten the hose fixing ring with a vise, and the hose will be loose. Remove the hose. First, adjust the car to the power-on but not ignition state, and find two bricks to press the accelerator. Next, wipe the dirt of the throttle valve with a wet wipe.

5. How to clean the throttle valve 1 Rub it with hot oxalic acid solution, or apply some potassium permanganate solution. 2 Rub it with soap or a small amount of warm milk.3 Old stains can be washed with detergent first, and then washed in 10% alcohol or 5% acetic acid solution.

6. The cleaning method of the throttle valve is as follows: the cleaning agent is mainly used to clean the main channel, valve sheet, side channel and idle stepper motor of the throttle body.

How to clean the throttle valve?

The cleaning method of the throttle valve is as follows: the cleaning agent is mainly to clean the main channel, valve sheet, side channel and idle stepper motor of the throttle body.

The cleaning steps of the throttle valve are: turn off the ignition switch and remove the negative pole of the battery; remove the throttle cable, intake hose and screws fixing the throttle valve in turn; clean the throttle valve with detergent, and wipe the parts that cannot be cleaned with cotton thread.

[Pacific Automobile Network] Car throttle valve cleaning method: first use the throttle valve cleaner to melt the carbon, gently push open the page with your hand, and brush the gap with a toothbrush; wash the carbon with a carburetor cleaner; repeat several times until the original metal color leaks from the throttle valve.

The process and precautions of cleaning the throttle valve by yourself

1. The cleaning steps of the throttle valve are: turn off the ignition switch and remove the negative pole of the battery; remove the throttle cable, intake hose, and the screw to fix the throttle valve in turn. Silk; clean the throttle valve with detergent, and wipe the parts that cannot be cleaned with cotton thread.

2. First of all, pull out the car key, open the hood, and find the throttle valve of the engine. Remove the air filter and intake pipe with a flat screwdriver, and unplug the electrical socket on the throttle valve;Then use a hexagonal screwdriver to unscrew the three hexagonal screws on the throttle valve (pay attention to this step and be careful of the screws "playing missing").

3. rn notes: rn first remove the intake hose outside the throttle, take the tool to step on the accelerator, or find someone to step on it. Do not pull it open by hand, which will damage the gears and limit mechanism in the throttle valve, especially when the ignition switch is on.

Audi A4L throttle cleaning method

1. The throttle cleaning method of Audi A4L is as follows: Step 1: Prepare tools. No. 10 small wrench (disassembly of the battery wiring pole), large Phillips screwdriver (disassembly of the air intake elbow), inner wrench T30 (disassembly of the throttle valve), a bottle of carburetor cleaner.Step 2: Remove the throttle inlet elbow. Step 3: Unplug the trottle harness plug.

2. Use a special cleaning agent or carburetor cleaning agent, spray a little on the throttle valve, and the carbon is completely dissolved by the organic solvent. Wipe the stain clean after 1-2 minutes. In addition to the above method, there is also a cleaning method that does not need to disassemble the throttle valve. When the engine is running, the cleaning agent can be sprayed into the throttle valve.

3. If it is not too dirty, you can use the method of removing the throttle valve and directly use detergent to clean the throttle valve. However, removing the throttle valve can be cleaned more cleanly.