USA customs data analysis services

List of contents of this article:

• 1,How to improve power due to poor motorcycle power
• 2、 How to modify a radial engine with a motorcycle engine?
• 3, Can the motorcycle engine be modified into the power of the pump
• 4, How to install a turbocharger on a motorcycle
• 5, How to modify the front heat dissipation of the Haojue vf100 pedal motorcycle engine

How to improve power with poor motorcycle power

Motorcycle power enhancement method: brush ECU. After motorcycles entered the fourth era of China, their fuel supply system was no longer a conventional carburetor, but a more precise electric injection system. The integration of the system not only has higher fuel supply efficiency, but also provides operability to improve performance.

Increase the air intake: After modifying the mushroom head, the air intake can be significantly increased (about 50%), but after modification, your car may not be able to refuel and add it, etc.

Clean or replace the air filter to ensure the normal intake of the motorcycle. ( 3) Clean the oil pan and replace the oil filter to remove the carbon and impurities of the oil pump to ensure the normal oil supply of the engine. ( 4) Replace the fuel filter, clean the fuel system or repair the fuel pump, etc. to ensure the smooth operation of the fuel system.

The most direct and effective way to improve the power of the motorcycle engine is to expand the cylinder of the engine and increase the emission of the machine to get the desired power. Of course, the cost will be high. After all, this is a technical job. It is best to find a professional or a reliable and trustworthy maintenance master.

The easiest way is to use better synthetic engine oil to reduce the friction coefficient between the engine piston ring and the cylinder block, shaft and tile, and gear, maximize the efficiency of the engine, and then improve the engine power output.

How to modify a radial engine with a motorcycle engine?

General marine engines must be equipped with a gearbox with forward gear and reverse gear. As long as the power output shaft of the engine can be connected to the gearbox, it can be used. Of course, it is also necessary to install equipment to operate the rudder and pull the wire to control the trottle.

If you are a water-cooled engine, it is the best. If it is an air-cooled engine, it is difficult to do. The speed of the boat is very slow, and the engine load is heavy and the heat dissipation is not good. Remove the igniter, battery and fuel tank on the motorcycle, otherwise the engine will not work. As long as the oil line circuit is normal, it can work normally.

Yes. Most of the 70 and 110 motorcycle engines are horizontal cylinder engines. The installation holes of many engines are similar, and other external parts are also similar. If some parts are properly modified and replaced, the original 70 engine can be replaced with the 110 engine. But it's better to replace the original carburetor, otherwise the speed will be almost accelerated.

It is not so simple to change the horsepower. Any change in the trottle line will not increase the horsepower. Must: either change the ratio of the combustion chamber and the cylinder volume, or increase the air intake (turbocharged). The diesel engine (tractor) adopts the pressure blast type. The piston stroke is long, and the cylinder body is under great pressure. It can't be started with spark plugs.

First, convert the voltage of the motorcycle generator to alternating current, and then boost it to 220 volts with a transformer. The starting motor of the motorcycle is a generator, which can be used directly.But the electricity of his high-voltage coil is not good, because the voltage is high and the current is low.

Yes, this kind of piston engine was used in the spiral slurry aircraft in those years. Motorcycle engines can be used as engines for power triangular wings, ultra-light single-person aircraft, etc., but the power is required to be large enough. If you want to make your own small plane, it is recommended that you search for information about ultra-light aircraft on the Internet.

Can the motorcycle engine be modified into the power of the water pump

1. To modify the power of the motorcycle engine into the water pump, you must first solve its heat dissipation problem.

2. Yes, you can search for motorcycle water pump on Taobao. There are about 100 yuan. I have sold it before. The effect is not bad.

3. Surely possible. As long as the power output of the engine can be connected to the water pump and drive the water pump, water can be pumped. However, the engine must meet the technical requirements of the power and working speed of the pump.

4. If the engine of the motorcycle is used to drive the external water pump, it is not good for the engine and will inevitably increase the wear of the engine. Moreover, if it is not a water cooler, running in place for a long time will cause the engine to dissipate poorly and cause high temperature, and may also cause serious failures and damage. Bad.

5. If you don't often drive long distances, it's better not to modify it. Water cooling is more troublesome in terms of repair and maintenance.

How to install a turbocharger on a motorcycle

1. Open the engine shell and find the power unit.Separate the wires. Connect the turbocharger according to the wire. Pay attention to ensure the lubrication of the turbocharger. When pre-moistening the turbocharger, pay attention not to let the lubricating oil soak in the supercharger.

2. This is simple, but first of all, it should be clear that your Fuxi has modified the electric injection system, and only the electric injection vehicle can be modified. Turbochargers are sold on Taobao, which is very cheap for more than 200 yuan, and the electric injection system is more than 700 yuan.

3. Please, I know that it is an illegal car modification, and I also know that JC will be stopped. I want to know the role of the motorcycle engine to install a turbocharger and what model of turbocharger and the process of modification. Money is an external thing.

4. Just install it in front of the carburetor. Turn on the switch and it will work.

5. If it is a simple supercharging device, it is enough to install a fan in front of the air intake of the air filter. Some people have changed it, and there will be a little improvement in motivation, which has little impact on other aspects.

How to modify the front heat dissipation of the Haojue vf100 pedal motorcycle engine

The forced air-cooled engine used by pedal motorcycles generally requires a riding time of no more than 45 minutes. Under normal use, the engine generally does not overheat. Due to the limitations of the driving structure and the installation position of the engine, the heat dissipation system cannot be modified.

Under normal use, the air cooling designed by the original car is sufficient. There is no need to modify it. You can modify it by yourself.The oil cooling effect will not be good (including the so-called oil-cooled cars from some factories), and there are many sequelae after modification. Generally, as long as motorcycles are not used under heavy load for a long time and the oil circulation is normal, it will not overheat.

Keep the amount of coolant sufficient. If the liquid level is lower than the lowest mark of the expansion tank, it should be added in time. When the engine is in a cold state, the coolant liquid level should be located between the highest and lowest marks of the expansion tank. Note that the coolant in the expansion tank should not be filled up, and there should be room for expansion.