How to ensure tariff compliance

List of the catalog of this article:

• 1, Car cleaning and care common sense
• 2、< A href='# How to wash the car cleanestly?How to ensure tariff compliance' title='How to wash the car cleanest?' > How to wash the car cleanestly?
• 3, What should I do to clean the car by myself
• 4, How to clean the vehicle (operation steps for car cleaning)
• 5 
  、How to clean a car< /Li>
• 6,How to ensure tariff compliance Wash at home What to wash the car

common sense of car cleaning and care

1, it should be cleaned with substances containing strong acid and alkali properties. In addition, when cleaning, pay attention to avoid corrosion of audio, radio, CD and other electrical equipment. Car paint maintenance The common sense of car paint maintenance is actually very complicated.

2. Knowledge 3: Selection of tools and supplies When washing a car, there should be a division of labor between car washing equipment. The bear's paw is used to clean the car body, the long hair is used to brush the rims, and the sponge is used to wash the tires. It should not be confused, and the top-down principle should be followed.

3. It should be cleaned with neutral detergent, and must not be cleaned with strong acid and alkali substances. In addition, when cleaning, pay attention to avoid corrosion of audio, radio, CD and other electrical equipment. Car paint maintenance The common sense of car paint maintenance is actually very complicated.

How to wash the car cleanestly?

1. Detergent car washing The main component of detergent is also sulfonic acid, and general detergent is also an alkaline product. Although some detergents are also neutral, long-term use will hurt your hands, such as hand peeling. Therefore, it is not appropriate to use washing powder and detergent to wash the car.

2. That is, wipe the car wash liquid on the car body with a car wash sponge, and then use a high-pressure water gun to rinse the car clean. Remove stains. Carefully remove some residual stains on the car body, which requires the use of descaling water. Note: When removing stains, wipe in the direction perpendicular to the car.

3. Car cleaning is divided into two parts, one is the exterior of the car and the other is the interior of the car. The complete car washing method is to spray detergent on the surface of the car, especially the gap next to the steel ring and the door. You can use the same detergent or different special detergents.

4. The method of cleaning the car: First, keep the car in a cool state and wash the car in a place where there is no direct sunlight. Otherwise, the light is easy to dry the foam, which is difficult to remove during the car in the later stage of washing.Wet the car with a water gun, and then put the car cleaner on a towel or sponge to wipe the car thoroughly. Then the order is also very important.

5. It is easy to leave a lot of wax residue around the taillight, and it is difficult to remove it no matter how carefully you wipe it. The best way is to remove all the lamps and clean them. There are also many small parts that need to be cleaned. It is easy to clean up if you make up your mind to clean it carefully and slowly. Many people's car bodies are clean, but the bumpers are not maintained.

6. Remove the dust. Fill the bucket with a bucket of water, or if there is a water pipe, wet the car body directly, rinse it, and then wash the car body on the roof first. The purpose is to clean the dirt or sand on the car body to prevent scratching the car paint when washing the car. Choose car wash liquid.

What to do to wash the car by yourself

1. Wash the car by yourself should be pre-washed first, then rinsed with warm water, and then choose the correct car washing liquid to clean. The specific method is as follows: Pre-washing Professional car wash should add a pre-washing work before washing the car.

2. First of all, drive the car that needs to be cleaned to a relatively open position, preferably close to the faucet, so as to facilitate water cleaning. Be careful not to wash the car in places with a large number of vehicles, so as not to affect the normal traffic operation. Prepare the car wash tools. The car wash tools that I often use include long-handled mops, car wash liquid, water basins and car wash towels.

3. First, do the first process, clean the car body for the first time, and clean the surroundings with a long-handled mop. If there is a long water pipe, you can rinse the body with a water pipe first, and then wash it with a mop.Then wash it with car wash liquid. First, mix the car wash liquid and pour about 3 lids of car wash liquid into the water tray.

4. Therefore, you should also choose a soft cotton brush or sponge to wash your car by yourself. It is best to use high-quality (knitted) towels and deer skins when cleaning the car. Some car owners don't want to go to the car wash. They felt that the car was so dirty that they couldn't stand it anymore, so they carried the bucket to wash it by themselves.

5. First, prepare the tools needed for car washing, a large rag, car wash detergent, and water pipes. The place to wash the car should be as wide as possible, because the car wash will produce a lot of water. Wet the car body first, and then apply detergent.

6. Self-washing method: Generally, you need a car wash hose to wash your own car. But if not, we can use the following method: Steps: Find a basin, put some detergent in the water (it's better to use car wash powder), dip it with a mop, and mop it directly.Put the water in the basin and pour it into the car until it is washed.

The method of cleaning the vehicle (operation steps of car cleaning)

At this time, the main flushing should be: when flushing the parts above the middle, the water flowing down can basically flush the lower part and bottom It's clean, so just pass through the lower part and the bottom. While A was washing the car body, B entered the car and scrubbed the interior parts of the car with a semi-wet towel.

Flush the car body with a water pipe in order to wash away a little dust and sand. The order starts from the front and rear covers of the sunroof and the surrounding hubs, etc. Use a special car cleaning liquid to clean the sea surface of the car. The solution is to fully soak the car cleaning liquid and the sea surface where the car is cleaned, and then spray the car cleaning foam on the car.

The steps and methods of car washing The typical process of car washing is: washing, brushing, washing, then washing, drying, nursing, inspection and acceptance. 1) Cleaning: Drive the car to be cleaned to the washing position of the cleaning workshop, tighten the handbrake to stop the engine, close the doors and windows, and no one is allowed in the car.

Specific steps for car washing: The car wash should be carried out in a place where the car body is cooled, in a place where there is no wind and no direct sunlight, and it should be cleaned with a towel or sponge. The order of car washing is best the roof, hood, and both sides, and at the same time, the car body is cleaned in a certain direction, so that the decontamination effect is better.

Car cleaning is divided into two parts, one is the exterior of the car and the other is the interior of the car. The complete car washing method is to spray detergent on the surface of the car, especially the gap next to the steel ring and the door. You can use the same detergent or different special detergents.

Car cleaning is divided into two parts, one is internal cleaning and the other is external cleaning.

How to wash the car

1. Wash the car with water every 2-3 days. If it rains, you should wash your car once a day, or immediately when the weather is good. When the car body is dirty, wipe the whole car with detergent, and then rinse and dry it with water.

2. Car cleaning is divided into two parts, one is the exterior of the car and the other is the interior of the car. The complete car washing method is to spray detergent on the surface of the car, especially the gap next to the steel ring and the door. You can use the same detergent or different special detergents.

3. Wash the whole car.First of all, rinse the whole car thoroughly. Since it is the first rinse, it can be roughly cleaned like the usual car wash. Deep cleaning of wheel hubs and tires. Use a special hub cleaner to clean the hub with a brush. Be careful when cleaning, and clean the brush as deep as possible.

4. The operation process of car cleaning is: washing the whole car; deep cleaning of wheels and tires; cleaning the seams of the whole car; washing the whole car for the second time; vacuuming in the car; wiping the interior and glass of the car; using an air gun to blow the moisture in the gaps of the body cover.

What do you use to wash your car at home

Use detergent to wash your car at home, washing powder instead of foam. Wash the car with detergent. The main component of detergent is also sulfonic acid, and general detergents are also alkaline products.Although some detergents are also neutral, long-term use will hurt your hands, such as hand peeling.

Wool gloves and car wash sponges are mainly used to scrub the car body. It is recommended to wash the upper half of the car body with wool gloves and the lower half of the car body with a car wash sponge. This helps to avoid cross-contamination and prevent the dirt in the lower half of the car body from being brought into the upper half of the car body, causing scratches on the car paint.

Then, scrub the car body with the car wash liquid absorbed by the sponge. When cleaning the car, scrub it from top to bottom and from front to back. In this way, the water flows down from a high place, almost washing the roof of the car, and the car body and the lower part are almost washed away by the running water, which saves both water and effort.

Spray wet. Use the MINI car wash machine to spray the car evenly from top to bottom, subject to the soil on the car body. Function - Soften the dirt and dust stuck to the car body!Spray washing. Use the MINI car wash machine to spray and flush from top to bottom. Function - Wash away more than 90% of the dirt on the car body; scrub.

What if there is no foam when we wash our own cars at home? It's very simple. First, rinse the car with water, then mix the softener used for washing clothes with clear water (a basin of water is enough), wipe the car body with water with softener, and finally clean the car body with water.

You need to prepare the following things to wash your car at home: water pipes, basins, towels, high-pressure water guns, and car wash liquid.